河南洗浴中心一条龙-河南洗浴中心一条龙_首页

在滁州酒店晚上怎么叫服务

Hotline:

thirteen billion six hundred and thirty-two million nine hundred and sixty-three thousand four hundred and forty-six



National Service Hotline: thirteen billion six hundred and thirty-two million nine hundred and sixty-three thousand four hundred and forty-six

Shenzhen: thirteen billion six hundred and thirty-two million nine hundred and sixty-three thousand four hundred and forty-six

Suzhou: fifteen billion eight hundred and sixty-two million six hundred and eighty-three thousand five hundred and sixty-four

QQ: one billion four hundred and ninety-three million seventy-nine thousand and eleven

WeChat: secyao

Email: 1493079011@qq.com

What is the setting time of dispensing machine?

Release time: October 11, 2019 10:18:44 source: http://1xuewen.com
 What is the setting time of dispensing machine?

1. Working pressure setting of dispenser

The fully active dispensing machine supplies the corresponding working pressure for the needle or glue gun to ensure the supply of glue,
 Working pressure determines the amount and speed of glue. If the working pressure is too high, the glue will overflow,
 Too much glue. If the working pressure is too small, there will be indirect and leakage points and other adverse effects
 Glue quantity control phenomenon, which will form commodity defects, should be in accordance with the nature of glue and working environment
 Confirm the working pressure. The working temperature will reduce the viscosity of glue and make it flow
 The general effect is good. The working pressure should be reduced and vice versa.


2. Setting time of dispenser

According to the working experience of glue quantity control, the diameter of glue spot should be half of the commodity interval
 One. This will ensure that there is enough glue to bond the parts and avoid excessive glue
 The amount of dispensing is determined by the set length of time. In social practice, it should be made according to the production
 We need conditions to confirm the initiative Dispenser  Set the duration.

3. Outline dimension of dispensing machine needle

In practical work, the inner diameter of the needle should be about 1 / 2 of the diameter of the glue spot. In the fully active dispenser
 The whole process should be based on the amount of glue control and the overall size of the commodity. Confirm the active dispensing head
 Should be different needle size of different products, so as to ensure that the owner
 move Dispenser  Control the quality of glue point products and improve the production efficiency.