临汾夜总会-临汾夜总会_主页

在滁州酒店晚上怎么叫服务

Hotline:

thirteen billion six hundred and thirty-two million nine hundred and sixty-three thousand four hundred and forty-six



National Service Hotline: thirteen billion six hundred and thirty-two million nine hundred and sixty-three thousand four hundred and forty-six

Shenzhen: thirteen billion six hundred and thirty-two million nine hundred and sixty-three thousand four hundred and forty-six

Suzhou: fifteen billion eight hundred and sixty-two million six hundred and eighty-three thousand five hundred and sixty-four

QQ: one billion four hundred and ninety-three million seventy-nine thousand and eleven

WeChat: secyao

Email: 1493079011@qq.com

Structure principle of dispensing machine

Release time: September 10, 2019 14:16:05 source: http://1xuewen.com
 The structure and principle of dispensing machine.

Compared with the traditional manual dispensing operation, the use of dispensing machine to complete dispensing operation will be more and more
 Convenience, no matter what products are produced in the production process, if the manual operation is selected, then
 It will consume a long time and energy, together with a large error rate, so it will be greatly
 The production power and production time are reduced because the workers have to be paid
 On the other hand, it increases the production cost, so it is not cost-effective Dispenser  Of
 Then, there is no need to worry about any errors, because its program is set to
 Ensure that there is a good dispensing operation, together because it can automatically complete all operations,
 In this way, there is no need for manual operation, thus greatly reducing the use of labor and production
 The cost and production power have been greatly improved.


The automatic dispenser sends compressed air into the syringe or bottle to press the glue into the piston chamber
 In the connected feed pipe, pressure is used for dispensing operation. When the piston is on the upstroke, the piston chamber
 When the piston pushes down the dispensing needle, the glue will be pressed out from the needle tip.
 The amount of glue dripping is determined by the interval of piston down stroke, which can be adjusted manually or programmed
 Control.

Dispensing machine is composed of three systems: performance system, drive system and control system. Dispenser Shoes
 The line organization is mainly responsible for the dispensing operation, and the driving organization can help the implementation organization to be more accurate and higher
 The realization of quality dispensing, and these of course also depends on a scientific and reasonable control system.